Hi Tom,
>I have posted a scan setup from today. The video shows a single line through the center of the penny. Exposure time was set at 1/3840 seconds and the resolution was 640x480. Mirror (left to right) and Flip (top >to bottom) were selected since the camera is upside down.
Thank you, that was very useful. I do not have the facility to set the exposure time, the camera is taking 29.970 frames/sec and that's it.
>I think that only the FOV is different. I changed it from 18.1 degrees to 15.4 degrees and got better proportions on the penny. This is about right for the +12mm focal length lens that I use on the Digi Watchport/>V2 camera.
I have set the FOV to 70 which when calibrated with a 1" Styrofoam block give a distance approx right. The x-y dimensions seem also right.
>> 2. I have loaded the file thubin080712CloudPenny03.txt in MachCloud but when I go to mesh it the cloud disappears and no mesh is being done.
>> Have you mesh that cloud? If yes what settings do you make on the BallPivot mesh panel?
>I could not get meshing or any of that kind of stuff working in MachCloud. I have not tried that in Rhino.
It seems that if the dimensions of the object are too small (not the number of points in the cloud) meshing swallows it
>What camera are you using? Do you know the lens focal length? Do you know the field of view?
http://www.supercircuits.com/Security-Cameras/Board-Cameras/PC302XS with a digitizer The resulting image is 640x480 and black and white
I have found that the if I lower the voltage on the laser line generator I get a cleaner image of the line.
I have to work on my setup so I can change the distance between the camera and the laser easily. Right now the laser is pointing straight down and the camera is at ~45deg.
As for meshing in Machloud:
I do not understand what the Delauney Set is used for
BallPivot mesh seems to works ok with the Prop.txt supplied by Art but I have not so far succeed to pick winning values for the Ball Diameter, shortest Edge and Max Angle to produce the same kind of results on anything I have scan so far. I am using inches dimensions. I wish somebody could explain how to set those parameters?
Regards,
Gaston