141
General Mach Discussion / Sanyo Denki BL Super servos
« on: January 26, 2007, 10:01:51 AM »
Hi
I just got myself 4 Sanyo Denki BL Super servos for free, inkl drives.
I just briefly looked trough the manuals , and it looks like they can be used for positioning control by negative command pulses and positive, they also have encoders for feedback.
Does anyone know if this equipment is possible to run under Mach 3?
I am planning to substitude my steppers for these servos.
They used to be controlled by an Omron PLC.
Best Reg
Cory
I just got myself 4 Sanyo Denki BL Super servos for free, inkl drives.
I just briefly looked trough the manuals , and it looks like they can be used for positioning control by negative command pulses and positive, they also have encoders for feedback.
Does anyone know if this equipment is possible to run under Mach 3?
I am planning to substitude my steppers for these servos.
They used to be controlled by an Omron PLC.
Best Reg
Cory