101
General Mach Discussion / Weird toolpath by LazyCam
« on: December 03, 2007, 01:56:10 PM »
Dont know if this belongs in LC forum or here, but I´ll try it here
Just upgraded to Mach 3 v 2.60, but now I get all sorts of strange toolpath, NOT AT ALL what i draw i acad or posted from LC.
ANy idea what this could be.
Worked great until I updated Mach 3
Se attached pics
Best reg
Cory
Just upgraded to Mach 3 v 2.60, but now I get all sorts of strange toolpath, NOT AT ALL what i draw i acad or posted from LC.
ANy idea what this could be.
Worked great until I updated Mach 3
Se attached pics
Best reg
Cory