1
General Mach Discussion / Re: PID In MACIV
« on: August 31, 2006, 03:53:12 PM »
Plz see this application note for DC Servo Motor by microchip(www.microchip.com).
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1824&appnote=en011782
This code uses RS-232 commands(Data being in quadrature encoder pulse units) to move the DC Servo motor to desired position. The velocity and acceleration are also programmed via Serial Interface into PIC MCU.
Can we make MECHIV to send position data in the form of serial commands on COM Port(RS 232), rather than generating pulses at certain velocity on Parallel Port, to move the motor to desired position.
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1824&appnote=en011782
This code uses RS-232 commands(Data being in quadrature encoder pulse units) to move the DC Servo motor to desired position. The velocity and acceleration are also programmed via Serial Interface into PIC MCU.
Can we make MECHIV to send position data in the form of serial commands on COM Port(RS 232), rather than generating pulses at certain velocity on Parallel Port, to move the motor to desired position.