Hello Guest it is May 22, 2024, 03:58:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Mikkef

Pages: 1
General Mach Discussion / Re: I need help with Mach3 setup.......
« on: June 13, 2009, 11:15:51 AM »
Thank's Hood.... The Reset button is OK now...

I need also help so I can get access to my step motors....


General Mach Discussion / I need help with Mach3 setup.......
« on: June 11, 2009, 05:41:36 PM »

I need some help to get the basic settings in Mach3. I have a Xylotex 3 axis driver board and Win XP SP3.

I need help with settings so I can get contact with my control cards, etc..

I hope there is someone who can help me with this... Thank's

I have these settings:

Port 1 Enabled
Kernel Speed 25000Hz

X axis step pin = 2  Dir pin = 3
Y axis step pin = 4  Dir pin = 5
Z axis step pin = 6  Dir pin = 7

Reset button blinks " Emergency Mode Active " nothing happens whether I press the button..?
Status: External EStop Requested.

How do I best be this problem ..?

Sorry for my English spelling ... I am from Sweden ....


FAQs / How do I change the z-Axel in Mach3.....
« on: July 01, 2008, 05:20:29 AM »
I have Mach3 ver 3.41 and I need to know wher In the setup I can change the Z - axel.
In the G-code it's G-1.0000 and my Z axel go upp and this is wrong...

I whant to change so the Z-axel go down with G-1.0000...  ???and up with G1.0000

Please let me know how I do this... Thank's


Pages: 1