Messages

1

General Mach Discussion / Re: anyone know where to get an optical edge finder?

« on: October 22, 2006, 01:33:34 AM »

Look for a toolmakers microscope. Be careful to make sure that the crosshairs are centered when you use it.

2

Modbus / Re: Mod I/o Question

« on: October 16, 2006, 11:45:05 PM »

I'm going to use my for front panel stuff.

Feedrate Override, Spindle Override, MPG, buttons ....

3

General Mach Discussion / Re: Automatic Oiler

« on: October 16, 2006, 08:04:38 PM »

My machine already has an automatic oiling system plumbed and powered, it just needs to have a relay triggered to initiate an oiling. One of the outputs from Mach3 could be used to do this, if I had a way to tell it when.

Shawn
 

4

General Mach Discussion / Automatic Oiler

« on: October 16, 2006, 12:21:53 PM »

What is the best way to implement an automatic oiling function. It. would be better for it to happen after a certain amount of motion rather than time. I saw a post about using the macropump to do this. Can someone elaborate on this please?

Shawn

5

General Mach Discussion / Standard Configurations

« on: September 28, 2006, 01:55:09 PM »

Are there any standard configurations recommended? I mean for the assignment of ports/pins to a function. I would like to get my project started right from the beginning.

Shawn

6

Show"N"Tell ( Your Machines) / Re: Chads new machine

« on: September 18, 2006, 11:19:11 PM »

Chad this is an amazing accomplishment. I am proud of you.

7

General Mach Discussion / Re: Retrofit problems.

« on: September 18, 2006, 01:14:36 AM »

I agree, the Gain adjustment is very touchy.

8

General Mach Discussion / Re: New here and have a few questions

« on: September 18, 2006, 12:31:55 AM »

Anyone have experience or knowledge to compare the Skyko and Rutex products?

9

General Mach Discussion / Re: Galil

« on: September 14, 2006, 12:23:13 AM »

Anyone else out there going to be using Mach with a Galil when it is operational?

10

General Mach Discussion / Galil

« on: September 07, 2006, 12:52:44 AM »

I am very interested in the progress being made on a Galil compatible Mach. Can we get a teaser or two?

Shawn