Hello Guest it is May 09, 2021, 10:06:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jlautomatio

Pages: « 1 2 3 4 5
41
LazyCam (Beta) / Re: lazycam
« on: June 22, 2006, 10:30:42 AM »
hi Brian
in any diffren using lazy cam with mach 3  ver 1.90.041 and ver 1.90.051
thank you

42
LazyCam (Beta) / lazycam
« on: June 17, 2006, 09:57:44 AM »
Question
with ver 1 no problem
with vewr 2.53
i am using milling and wiht setup in lazycam
when the milling bit go down it ok but when it go up the z move in same time with x an y this is a problem and do the have a way to set up all the layer control an keep for next dxt

Pages: « 1 2 3 4 5