Topics

1

FAQs / Mouse doesn't work after closing mach3

« on: August 06, 2007, 04:11:08 PM »

I use a EPIA MINI ITX board and when I open mach3 it works good
but after  closing mach3 de mouse doesn't work more in WIndows XP
does some body now how to fix this problem.


                                                   best regard,s

                                                         Kees

2

General Mach Discussion / Setup slave A to X axis

« on: September 04, 2006, 02:56:16 PM »

Mach3 version D1.90.081

I want to setup in the motor tuning menu, the A axis as a slave to the X axis,  but it  isn't active.
Does somebody now why? i need this option for my router.

                                                                   
                                                                                    regard's  Kees

3

General Mach Discussion / Charge pump setting THC300

« on: August 26, 2006, 01:12:06 PM »

I setup my THC300 and the most settings are working only the torch on doesn't work
my pin settings are port2 pin1 as the manual says now i read some thing about the
charge pump settings is that my problem?

                                             Best regards, from the Netherlands

4

General Mach Discussion / THC300 arc voltage

« on: August 24, 2006, 04:12:12 PM »

What is the voltage range to adjust the arc distance while cutting.