31
Mach4 General Discussion / Re: Single block mode
« on: March 02, 2017, 04:55:43 PM »
On a real controller you enter single block mode the press cycle start to jump through the lines of code. I just assumed that mach4 would work in a similar fashion. It seems futile to have to hit single block, then cyclestop, then turn off then on single block then cyclestop, then repeat. I really wish mach4 had better documentation as to the functionality and how it works. It seems very counter productive to have to figure out how to operate the control and try to get things accomplished. Yes there are a lot of things that work as they should and expected, but there are also a lot of functionality that appears to be there but is tremendously lacking.