5081
General Mach Discussion / Re: single block problems
« on: November 21, 2006, 10:32:16 PM »
We may not have the same problem. Mine repeats like clock work. Can you not get yours to repeat now?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Mark,
 No, that is not how it should work. While code is running, I place in single block. It does stop at the end of the line I hit it on. But it jumps to the next line. On cycle start again the two lines are now a single move. If z is moving, I hit single block, it stops at end of line. Next line of code is a move in the x. I hit start, now the z and x are moving at the same time. This should not happen. Single block should simply pause the running at the end of a line of code. When you hit start again it should start back running as if single block was never hit. I think we gots bugs.  This is a problem.