4921
General Mach Discussion / Re: Rotational milling speed?
« on: December 20, 2006, 07:16:12 PM »
Hi JQ,
First, I'm running version 2.0.028. This is what I found. Your xml did not have the use diameter for feed rate checked. I ran your test file with this unchecked. The 4th axis was reading 17.1375 at 2:19 minutes into the cycle. With it checked, the 4th axis was reading 19.2750 0:04 into the cycle . Try to change this setting, close Mach. Open Mach back up and see if the change stayed and try to run your file again.
First, I'm running version 2.0.028. This is what I found. Your xml did not have the use diameter for feed rate checked. I ran your test file with this unchecked. The 4th axis was reading 17.1375 at 2:19 minutes into the cycle. With it checked, the 4th axis was reading 19.2750 0:04 into the cycle . Try to change this setting, close Mach. Open Mach back up and see if the change stayed and try to run your file again.