3921
General Mach Discussion / Re: Question around operation and parameters
« on: August 05, 2007, 09:26:46 PM »
Hey Paul,
Check out this thread.
http://www.artsoftcontrols.com/forum/index.php?topic=3849.0
There are lots of ways to do the tool change. Like you, I have not had much time to mess with this until recent. I have been learning a lot. You have 3 options for tool change in general config. Ignor, does as it implies, it ignores the M6 command in your g-code (that sholud be placed on the same line as your tool number. Ex. T3 M6). Then you have stop spindle. This will use both the m6 start and m6 end macros. Then there is auto, which only uses the M6 start macro. You can place code in the macros to do allmost anything you can think of. The one in the link sends the tool to toolcahnge position, 3 dros on your settings page, mid to lower far right. Ask if you want to do an auto tool zero and goes back to running your code.
I hope this helps,
Brett
Check out this thread.
http://www.artsoftcontrols.com/forum/index.php?topic=3849.0
There are lots of ways to do the tool change. Like you, I have not had much time to mess with this until recent. I have been learning a lot. You have 3 options for tool change in general config. Ignor, does as it implies, it ignores the M6 command in your g-code (that sholud be placed on the same line as your tool number. Ex. T3 M6). Then you have stop spindle. This will use both the m6 start and m6 end macros. Then there is auto, which only uses the M6 start macro. You can place code in the macros to do allmost anything you can think of. The one in the link sends the tool to toolcahnge position, 3 dros on your settings page, mid to lower far right. Ask if you want to do an auto tool zero and goes back to running your code.
I hope this helps,
Brett