Messages

3911

Mach3 and G-Rex / Re: G100 crashing?

« on: August 10, 2007, 08:22:52 PM »

Hey Wes,
    Mine works pretty well. There are still a few things I would like to see worked out, and may be now, not certain though. The homing routine seems finiky for some, mine works pretty well with only an ocassional hick-up.


Brett

3912

Mach3 and G-Rex / Re: G100 crashing?

« on: August 09, 2007, 05:03:18 PM »

Thanks for the report mhdale. Little things like that helps us all a lot. 

Brett

3913

General Mach Discussion / Re: More inputs or more outputs, you decide.

« on: August 08, 2007, 08:02:56 AM »

Bump   

3914

General Mach Discussion / Re: turn icon

« on: August 07, 2007, 09:38:09 PM »

Ok Todd,
   Is your lath profile missing all together or just the shortcut Icon takes you to mill? Look in your root Mach 3 folder C:/mach3 for two folders.  Mach3turn.xml and 1024l.set

Brett

3915

General Mach Discussion / Re: More inputs or more outputs, you decide.

« on: August 07, 2007, 06:32:06 PM »

Right you are LSD, Hmmmmmmmm, that didn't come out right.

All jokes aside, you are exactly right. That is the plan actually, more of each but it will most likely be heavier on one than the other so keep this in mind while casting your vote.

Brett

3916

General Mach Discussion / Re: USB output board instead of printer board

« on: August 07, 2007, 06:02:41 PM »

 

3917

General Mach Discussion / More inputs or more outputs, you decide.

« on: August 07, 2007, 04:14:46 PM »

OK guys, This is a question for all. This is going to help guide the development of a new product, so please vote. If you don't use a second port, still vote as to what you would like to see, more inputs, or more outputs. I know, more of both. But, if you had to choose, which would it be?

Brett

3918

Show"N"Tell ( What you have made with your CNC machine.) / Re: “Touch Probe” I think I made a good one

« on: August 07, 2007, 02:50:51 PM »

Good Job Gary, 
     Are you going to sell any of these? Have you tested these? Does it work fine after thousands of contacts?

Brett

3919

VB and the development of wizards / Re: G100 A/d inputs

« on: August 06, 2007, 10:35:50 PM »

I will try my best to look at this for you in a couple of days if no-one else has you straight. I'm running on a BOB right now and will be a couple of days before I finish the job it is running.

Brett

3920

General Mach Discussion / Re: turn icon

« on: August 05, 2007, 09:52:00 PM »

Also, it might be coming up with the 1024 mill set instead of the 1024L set for the lathe. You need to check the settings if you use both profiles to make sure your not changing the wrong one. If it is the lath profile and the mill screen, just go to view, load screen and browse to the 1024Lset.

brett