Messages

3891

General Mach Discussion / Re: Tool Change Output

« on: August 18, 2007, 08:13:18 PM »

Olf,
   Open Mach. look at the tabs at the top, operator, vb script editor, browse to mach 3 folder, macros, the profile you are using. Should find M6 start and M6 end there.

Brett

3892

General Mach Discussion / Re: Screen not full size in Vista

« on: August 16, 2007, 09:26:34 PM »

Do you have auto screen enlarge checked in general config? You might have to exit Mach and then re-open for it to take effect. Just a stab, never played with Vista.

Brett

3893

General Mach Discussion / Re: MDI does not respond

« on: August 16, 2007, 04:02:51 PM »

Your welcome  Glad you got it.

Brett

3894

Mach3 and G-Rex / Re: Whats do you all think is the best way?

« on: August 16, 2007, 11:57:13 AM »

Hey Mike,
   Maybe I'm misunderstanding. It does happen. I don't understand why you are saying probing. You could use the reflective sensor as an input I think. Your macro would look for that input. I don't think probeing is working on the Grex. I have sent you a personal message.

Brett

3895

General Mach Discussion / The latest G100 Set-Up Guide

« on: August 16, 2007, 08:36:47 AM »

The G100 Set-Up Guide is finished.

Brett

3896

Mach3 and G-Rex / Latest G100 Set-Up Guide

« on: August 16, 2007, 08:34:22 AM »

I welcome input from other members.

Brett

3897

General Mach Discussion / Re: MDI does not respond

« on: August 16, 2007, 07:32:18 AM »

Also, check out this link. It is a free screen capture program. It is very easy to use and you can save your shots as jpeg and other formats.

http://wisdom-soft.com/products/screenhunter.htm

Brett

3898

General Mach Discussion / Re: MDI does not respond

« on: August 16, 2007, 07:26:03 AM »

OK Jovimon, That helps a lot. A picture is worth a thousand words. THe problem is this, your not seeing all of your screen. Go to general config and check the box Auto Screen Enlarge, Its down at the bottom, center right. You may have to exit mach and re-open for this to take effect. You may need to play with other settings in Screen control, I don't think so though. Give it a go and let us know. If, when you open general cofig. the bottom it it is missing too, grap it at the top and slide it up so you can get to Screen control.

Brett

3899

Mach3 and G-Rex / Re: Whats do you all think is the best way?

« on: August 15, 2007, 10:11:46 PM »

Hey Mike,
   I would think you could set all of this in a couple of macros. Could add a couple of dros for each axis as far as posotioning I think. Would only need dros if it changed often, otherwise you could just put the code in the macros.

Brett

3900

Mach3 and G-Rex / Re: I need help configuring the I/O in Mach3 for the G101 or G100

« on: August 15, 2007, 06:53:42 PM »

Carl,
    No apology necessary. I didn't mean to come off so harsh. Lots of times we resort to other means of communication rather than the forum for different reasons. The biggest is for time. I hope you understand.

Brett