Messages

3511

General Mach Discussion / Re: edge finding/2.5D probing

« on: December 06, 2007, 07:17:24 AM »

Does anyone know if working off of the ( E ) drive will still affect certain things in/related to Mach?

Brett

3512

General Mach Discussion / Re: Mach3 Startup- Reboots PC- help?

« on: December 05, 2007, 10:39:41 PM »

Yeeeeeeeee Haaaaaaaaaa, it's alive. Sounds like your Vel. may be tuned too high, or possibly it is out of the KHz range. What is your steps per, vel., and accel. set to in motor tuning? What Pulse rate mode are you set to in config. Ports and pins, port setup.

Brett

3513

General Mach Discussion / Re: Keygrabber

« on: December 05, 2007, 09:27:23 PM »

I have sent you a personal message.

Brett

3514

General Mach Discussion / Re: Keygrabber

« on: December 05, 2007, 01:45:30 PM »

Sounds good walt. I'll be in and out this evening so we should catch up with one another sometime. You may also want to look at this thread too.

http://www.machsupport.com/forum/index.php/topic,1391.0.html

Brett

3515

Brains Development / Re: small brain slowing spindle speed

« on: December 04, 2007, 11:14:18 PM »

Try assigning it to a different key and see if it helps. I don't think K is taken by the default screen sets, not certain though. What screen set are you using?

Brett

3516

General Mach Discussion / Re: Keygrabber

« on: December 04, 2007, 11:10:58 PM »

Hi Walt,
    I'll help what I can.

Brett

3517

Modbus / Re: Modbus

« on: December 04, 2007, 09:03:18 AM »

bump

3518

General Mach Discussion / Re: Need Some Help!!

« on: December 04, 2007, 07:05:58 AM »

Walt, lots of the guys here are really good with VB. Might help if you will post the code.

Brett

3519

General Mach Discussion / Re: MACH3 ROCKS !!!

« on: December 03, 2007, 09:43:23 PM »

Addictive isn't it?   

Brett

3520

Mach3 and G-Rex / Re: VERY BIG PROBLEM with G00 by Mach3 with Grex100

« on: December 03, 2007, 09:29:18 PM »

Have you checked the actual posotioning with a dial indicator? I think it will be correct, but the dro updates are a little slow I think.

Brett