3171
General Mach Discussion / Re: Reset - I was wrong
« on: April 30, 2008, 10:16:45 PM »
Also might want to try view, save current view after putting your code in the button.
Brett
Brett
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I disagree. A limit is supposed to stop any further incursion past the limit switch. It is exacly that, a limit. It should allow no further movement in that direction, on that axis. It should stop any running program (if you hit a limit you have already screwed up), and it should stop any further movement on that axis, in that direction. It should NOT stop movement on that axis in the other direction, or movement on any other axis in ANY direction.