2981
Modbus / Re: Can A Modbus control a.........
« on: July 26, 2008, 10:50:33 PM »
The SS isn't a breakout board, it is the replacement of 2 parallel ports that can pulse much faster than parallel ports. You may still want to use a breakout board for opto isolation. You could use the SS plus a mod device or the G100 with the IO only plug-in. The g100 would be able to handel a good bit of additional I/O. Probably enough for for a pretty simple tool changer and if you can't find a G100 cheap, I'll sell you one. I wouldn't use the G100 for motion control but if it can handel all of the extra I/O you need, may be a cheap alternative to a PLC.. The SS is far superior to it as far as motion control. The disadvantge of haveing the SS control the tool axis is you will loose time on tool changes.
Hope this helps a little.
Brett
Hope this helps a little.
Brett