2661
General Mach Discussion / Re: Knee Mill Coolant Containment
« on: October 19, 2008, 01:16:41 PM »
Lookin good ED. We need to start a Pimp my Hyster Forum. LOL
Brett
Brett
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Brett,
You can use this *and* a full keyboard, they're not mutually exclusive. Windows is perfectly happy having multiple keyboard devices.
With a marker taped to the torch, it "cuts" fine every time. The amount deviated can be quite a bit, I measured ~.5" +Y and ~3" -X direction on one part. I thought interference might be causing the problem, so I separated the torch and motor cables, same thing. This problem occurs when using the THC or when not using it.