Messages

2391

Works in progress / Re: First try at a Screen

« on: March 11, 2009, 06:18:47 AM »

Your screen is looking good Sam.

Brett

2392

General Mach Discussion / Re: Pause/Feedhold LED broken again?

« on: March 10, 2009, 08:27:57 PM »

Chip, I haven't seen this yet myself but I think the problem in the one pic with the top and bottom of the led are visible and the sides aren't is a graphics update issue. Not a biggie. If it is what I think chances of that getting looked at are slim to none. The way the buttons work is when you push them they get slightly smaller to give an illusion of physically pushing a button. I have noticed minor quirks with this in the past but there are bigger fish to fry if that is the problem. Try editing the set and make the button over the led slightly smaller and I think that will fix that problem. In the picture where there is no feed hold led or cycle start led I think you pushed the stop button.    No really, there are 4 LEDs associated with feed hold and depending on which you have selected, that combonation is possible. The feedhold LED coould light on press or when everything comes to a stand still depending on which led you have selected to use. The start will deactivate as soon as you hit feed hold.

Brett

2393

General Mach Discussion / Re: Pause/Feedhold LED broken again?

« on: March 10, 2009, 06:45:12 PM »

  Thanks Greg.

Brett

2394

General Mach Discussion / Re: Pause/Feedhold LED broken again?

« on: March 10, 2009, 04:21:12 PM »

Greg, Mach3 R3.042.022 is ready for a test. Let me know if it fixes you up please. I hope to be back online in a few hours.

Brett

2395

Tangent Corner / Re: Metal shredder

« on: March 10, 2009, 04:15:14 PM »

Yup, thats a nicen. 

Brett

2396

General Mach Discussion / Re: Implementing 3 MPG's one for each of X Y and Z Axis

« on: March 10, 2009, 10:44:07 AM »

No problem.

Brett

2397

General Mach Discussion / Re: Implementing 3 MPG's one for each of X Y and Z Axis

« on: March 10, 2009, 08:29:38 AM »

Open and close your MPG flyout by pressing the tab button. Set the mode to MPG and Select the axis you want your mpg/s to control.

Brett

2398

General Mach Discussion / Re: Pause/Feedhold LED broken again?

« on: March 09, 2009, 07:09:38 PM »

Glad to know I am not loosing my marbles. 

Jury is still out on this one Greg. 

I'll post in this thread when the fixed version is ready for download.

Brett

2399

General Mach Discussion / Re: Pause/Feedhold LED broken again?

« on: March 09, 2009, 06:53:36 PM »

No Greg, you were right. I have been testing a new, yet to be released exe and it is fixed up in it.

Brett

2400

General Mach Discussion / Re: Pause/Feedhold LED broken again?

« on: March 09, 2009, 06:03:27 PM »

Greg, I just tested an exe and it works a treat  . System function and all 3 leds.

Brett