1421
General Mach Discussion / Re: Mach3 Soft Limits -- Not Stopping
« on: March 20, 2013, 09:51:53 AM »
Good deal!
Brett
Brett
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
My questions:Depends on your drives and how you wire them up. Your break out board can have some bearing on this as well.
What powers up the stepper drives? Just enabling the E-stop circuit, or is there a standby mode where you can be programming and such but the drives are off?
Is the best way to do this to create a profile for each machine type?
if I move 0.020", it'll end up fairly close, but some steps will move it 0.0015, some are right on at 0.001 and some 0.0005.