1411
General Mach Discussion / Re: Enabling Mach3 wizard
« on: March 20, 2013, 05:05:52 PM »
You should be able to just paste into your C;/Mach3 folder
Brett
Brett
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
thank you, Chaoticone, the lead is .5 " per rev ,it seems like that would be a 2 pitch , also the spread sheet has a default value of 10 in the micro stepping window, i am not familiar with that value. shouldn't it be something like 1/8 or 1/4? thank you very much richard .