1261
General Mach Discussion / Re: 3040Z issues again.....
« on: April 26, 2013, 07:49:56 PM »
Well, if its working I would just copy the xml that is working good and then copy it to a safe place like a thumb drive. I'm not sure what all may be wrong with the xml you posted but assigning hot keys is pretty straight forward. Just go to config., system hot keys, click on the axis and direction buttons and for each push the key you want to move the machine it that direction. Need to stick with the defaults though as you can get in trouble wondering away from them. X+ is right arrow, X- is left arrow, Y+ is arrow up, Y- is arrow down, Z+ is page up and Z- is page down. I would like to know if that is all that was wrong.
Brett
Brett