Messages

11

General Mach Discussion / Re: Asolutely dumbfounded guy!????

« on: May 13, 2011, 03:43:20 PM »

I believe I read on the Mach site somewhere they recommend an add in video card, the cpu is using cycles in the on-board graphics that will cause problems with motor operation. I added a high end video card to my system and the software runs much better now. Of course YMMV, 

jim

12

Mach3 under Vista / Re: Windows 7 config problems

« on: March 04, 2011, 12:10:52 PM »

  Thank you!!!!

I put the address indicated in resources in the field as you instructed and they now talk to each other 

I appreciate your quick response, I've lurked for years and finally got around to setting my machine up.

Thanks again,

jim 

13

Mach3 under Vista / Windows 7 config problems

« on: March 04, 2011, 12:40:04 AM »

Configuring Mach on Windows 7, using device manager to get port address of PCI parallel card it indicates a port address of EC03-EC07, this will not allow the port to work. Has anyone else had this situation, and how did you determine the actual address??

Win 7 runs programs better than Vista, but hides too many things from user access.

Thanks for your help.........I did search first.

jim