21
General Mach Discussion / Re: Wont run G code
« on: April 08, 2009, 05:49:41 PM »
reset not flashing
port and pins set correctly
port and pins set correctly
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I use Autocad 2004 Lazycam loads all the 3 available dxf save formats . I have to use the drawing screen that comes up when Autocad starts up. I get no problems with the dxf's I save .When I load a template and do a drawing Lazycam will not load the dxf .I wonder if thats the problem, I click new and enter for acad.dwg and save under whatever name I want.
Hope this helps
Brian