Messages

11

General Mach Discussion / Re: MACH 3 lockup

« on: June 03, 2009, 05:09:11 AM »

Thanks Hood I've fixed it.
Brian.

12

General Mach Discussion / MACH 3 lockup

« on: June 02, 2009, 01:13:40 AM »

Everything worked fine until I began to play with the jogging pendant(tab)
now jogging has stopped working and the DRO wont zero etc.
Brian.

13

General Mach Discussion / Settings problem

« on: May 26, 2009, 04:06:44 PM »

What controls the motor speed when using:-
Settings
Steps per unit
How much would you like to move?
" I put a value in"
click OK
and the motors go "like a bat out of hell"
Smiley
Brian.

14

General Mach Discussion / Re: New PlugIn just about done..

« on: May 10, 2009, 10:48:11 AM »

I'm still looking for a DIY pendant and not $148 for a box of parts.

15

General Mach Discussion / Re: screen size

« on: April 26, 2009, 11:21:36 PM »

Thanks Hood, it was already checked.
The funny thing is that I have two PC's both were showing a perfect screen
(full size) now they dont one shows a undersize screen and the other
an oversize screen .
Brian.

16

General Mach Discussion / Re: screen size

« on: April 26, 2009, 04:29:33 PM »

Yup its ticked and the screen is still not full
Brian.

17

General Mach Discussion / screen size

« on: April 26, 2009, 04:08:22 PM »

How do i adjust the screen size to fit my monitor?
Brian.

18

General Mach Discussion / Re: Wont run G code

« on: April 09, 2009, 06:21:33 PM »

Try this
Brian.

19

General Mach Discussion / Re: Wont run G code

« on: April 09, 2009, 05:31:12 PM »

Hood did you get my XML file?
Brian.

20

General Mach Discussion / Re: Wont run G code

« on: April 08, 2009, 06:10:32 PM »

The only error I found was under Config check
Output signal check
Pin for output found as not pins 1-9, 14, 16 or 17 unless using "modbus"??
This is wrong.

Please comment.
Brian.