Hello Guest it is April 18, 2024, 03:37:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kree8tiv

Pages: 1
1
Hello,

Currently operating with Y and C Slaved. Distance is different and gantry twists?  Have had similar issues if non-motherboard mounted parallel port used in the past.  Any suggestions?

Have tried noise and decreasing max frequency in Plug in Control to no avail.

Help apprreciated!

2
G-Code, CAD, and CAM discussions / G1 on every line causing choppiness
« on: November 03, 2006, 12:49:47 PM »
Hi,

I am experiencing a weird situation where our machine gets choppy if there are G1 codes on every line of a 3D file.  If the codes are removed the machine is much smoother.  Any suggestions on ways to overcome this in Mach?  We use a number of CAD/CAM packages, and some have posts that are not easy to modify.

3
VB and the development of wizards / Soft Limits in a Macro
« on: October 27, 2006, 05:22:21 PM »
Does anyone know the code I can put into a couple Macros to Enable and Disable the Soft Limits?

4
Hello,

Is there a way I can get my rapid rate to always run at top speed, even if the feed rate over ride is not at 100%?  I am using 1.90.073. 

Also, on my SET file, the SHIFT + Jog does not go at 100%.  Any suggestions.

Cheers,

Pages: 1