Messages

41

Finished Screens / Re: Mach SoftLight

« on: September 30, 2008, 02:39:49 AM »

I have found all the screen but this one , any help is appreciated still new to mach3

42

General Mach Discussion / Re: Learning GCode... How to guide?

« on: September 19, 2008, 10:36:06 AM »

Kristein thank you it also has a good tutorial on making arcs

43

General Mach Discussion / Re: help please

« on: September 19, 2008, 01:36:00 AM »

Hood the g2 - g3 inputs I already knew I just wanted an example of how a line or two of code would look like to get an arc or helix from point a to point b . once I have an example I can run with it

Kristin I will download that and give it a buz

thank you

44

General Mach Discussion / help please

« on: September 18, 2008, 03:59:09 PM »

Hello everyone , I have started using mach3 for about 2 weeks and am getting comfortable writing my own code but being a novice I need a bit of help..... . in the pictures below the motor mounts have some curvy lines . can anyone give me some G-code examples of what to input to make an arc instead of a strait line going from point -A to point-B

these are two motor mounts that I made last weekend for my RC boat that I uploaded to youtube

http://www.youtube.com/watch?v=e7wPxIIumNs

http://www.youtube.com/watch?v=gZOcxN7QspY

Thank you for any help.......................

45

General Mach Discussion / Re: changing stepper directions

« on: June 04, 2008, 03:02:06 AM »

Thanks hood , got her all strait now

46

General Mach Discussion / changing stepper directions

« on: June 03, 2008, 04:21:21 PM »

Got my control box hooked up but my  Z , Y , A  axis are going the wrong direction.....X is correct , can this be reversed in the software

thank you

47

General Mach Discussion / Re: Bi-directional Jogging

« on: June 03, 2008, 04:17:29 PM »

I ran into that also , mine was the pin asignments