Hello Guest it is March 29, 2024, 02:18:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - calico

Pages: « 1 2 3 4 5 6 7
61
Hood,
Thank you for your suggestion, so far i works, but I will try to the bigger project.

Thanks
Cal

62
when I do round pocket cutting, is not round anymore.
I think X axis is the problem.
if I test x 0 and x 50 and x 0 (repet) I found out it shift.

my question, how to narrow the probelm, is it the motor ? or the controller ?
how so find out the easiest way ?

should I test anything ?

thankyou for your help
Cal

63
thanks
no wonder I counld not find it the menu

cal

64
I could not found the "import DXF" from the Mach3, could someone tell me where the menu is ?
I just want to import DXF file direcly to Mach 3 ver 2.0

I can use Lcam of course but I want faster way.

cal

65
Newfangled Solutions Mach3 Wizards / Re: Wizard Update Notifications?
« on: August 21, 2006, 09:19:48 PM »
it's rev 2.7 nfs.
I just want to cut 80mm x 20mm rec. outter cut.
and it always cut from inner.

I hope I made a setting mistake on this.

NFS is hell of a program, I love it, so easy and cut time alot.

cal

66
Newfangled Solutions Mach3 Wizards / Re: Wizard Update Notifications?
« on: August 21, 2006, 08:59:59 AM »
Well I don;t think it's a minor, unless I make my mistake.
I did try cut rectangle, when I choose Inner or Outer Mill side it just do  inner cut, it won;t go outer cut.

btw, I just purchase Mach3 yesterday, do I have to pay for additional for this Cut rectangle ?

it won't show on the Gcode on mach3, it says unlicense wizard file.

cal

67
Newfangled Solutions Mach3 Wizards / Re: Wizard Update Notifications?
« on: August 21, 2006, 04:54:32 AM »
what's the latest ver now ?

cal

68
General Mach Discussion / newflange "Unlicenced Wizard massage" .. help
« on: August 21, 2006, 12:56:44 AM »
I just install mach3 Dev. Version 1.90.074 (just purchaced), and I got this error when I run newflange wizard.
but the other wizard works fine.

any idea ?

cal

69
Hi, I'm looking for any information regarding 3D cutting (wood), specially about the hardware they use, like spindle, bit, where to order, etc.
any website abou this info ?

regards
cal

Pages: « 1 2 3 4 5 6 7