Hello Guest it is March 29, 2024, 01:52:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - calico

Pages: « 1 2 3 4 5 6 7 »
31
I have not got time to open the controller box yet to check the voltage.
what happened if the voltage drop ?
what's the tolerance ?

just to make sure, to check is the voltage/PSU that goes to the Gecko controller right ?

32
omg forgot to check that, that will takes time to open the controller casing.


33
ok guys,
bad news. I have the problem show up again.
losing steps.... not on Z. never lose on Z.


I'm stuck, I have no problem cutting straight pocket or anything that straight on X or Y.
but the problem sometime appear on radial cutting, specially with Z depth Radial cutting.
never lose on the exact spot !

help ...

34
Ian,
noted.

thanks, will check an try that

Cal

35
Hood,
thank you very much for your help and support, I appriciate that.

I will do the kernel to 25 like I used to be.

Cal

36
jere is the correct one,
sorry for giving you the wrong xml

37
btw I use 100Khz kernel .. is this too fast for my PC ?
I was using much lower before but give me the same result

38
strange, I just check to Genereal config, it's already 200 for look ahead.

yes it move the correct distance up to 0.3 mm accuracy if I command, maybe less.
I'm not really sure it's 5mm.

40
I just upgrade the mach to the latest 1 month ago.

increase to 50 will be ok ?

Pages: « 1 2 3 4 5 6 7 »