Hello Guest it is March 29, 2024, 09:32:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - catch22

Pages: « 1 2
11
General Mach Discussion / Hooking up limits!
« on: January 30, 2008, 09:32:06 PM »
Ive got my limits hooked up right now and they work great but they are hooked up through the ground and in the artsoft video he says the best way to have your limits wired a different way not using active low like I am. Can anyone tell me how to wire up my limits so that they are not active low. The limits im using are Normally open and normally closed with a ground. Any input would be greatly appreciated.

Thanks Mike

12
My machine acts really crazy for a second when I turn on the computer and its even worse when I shut it down.Its moving for a second or two it kinda freaks me out. Anyone have any suggestions,or comments!!

Thanks Mike

13
General Mach Discussion / How do I backup my settings?
« on: December 19, 2007, 09:59:29 PM »
Just wondering if anyone can tell me how to save my mach3 settings.I just finished configuring my mill and want to save the settings just in case the computer decides to die on me.Thanks Mike

14
General Mach Discussion / Mach3 wont reference all home
« on: December 18, 2007, 08:08:34 PM »
Mach3 wont reference all home,nothing happens when I press the reference all home button it will only let me home in the diognostics page. Can anyone help me out with this? Thanks mike

15
General Mach Discussion / mach3 not saving my x and z
« on: August 14, 2006, 09:57:28 PM »
when i pick up my x and z and machine a part when im finished and i close mach3 down it says save tools and fixture and i say yes. but when i restart it again it looses my numbers and i have to recalibrate x and z again. any help here would be greatly appreciated.

Pages: « 1 2