Hello Guest it is March 28, 2024, 03:36:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - catch22

Pages: 1 2 3 4 »
1
Are the servo motors and drives still available, and if so how many of each do you have.
Thanks Mike

2
Bargain Basement / Re: ESS (Smooth Stepper) - $115
« on: February 12, 2019, 08:48:45 PM »
Is the ess still available?

3
Can you tell us what the difference between the Neuron Lite and the Neuron Pro.
And can you tell us the price difference also.

Thanks Mike

4
Yes some do take step and direction.

Thanks Mike

5
General Mach Discussion / Compumotor servo drives for conversion?
« on: May 11, 2011, 09:07:31 PM »
I have a small cnc mill that I built and I use the compumotor zeta4 stepper drives and bipolar stepper motors.
They are great drives and I was wondering if anyone has used there servo drives with Mach3 and how they worked out because I would like to try them in my
cnc Mill conversion if they are compatible. ???

Thanks Mike

6
It doesn't look like they sell the Teco Drive by itself they are all priced with servo motors,unless there is somewhere else to purchess them?

Thanks Mike

7
I have a 1981 Excello 604 cnc mill with an old dynapath m5 control that I am going to convert to Mach3.
The mill has 85volt 28amp 1700 rpm servo motors and westamp drives as of now.
I am thinking of going with either Granite drives or the Dugong drives for my conversion and was wondering if anyone has any opinions on these or
other drives I would really appreciate it.I am trying to keep this conversion at a reasonable cost so anyone with a different drive that will work and save me some cash would also be a consideration.


Thanks Mike ???

8
General Mach Discussion / Re: X axis moving in only one direction?
« on: June 08, 2010, 07:12:00 AM »
I switched drives and it does the same thing,but I noticed that Im getting a message that says softlimits system movement aborted?

Does this help at all?



Thanks Mike

9
General Mach Discussion / X axis moving in only one direction?
« on: June 06, 2010, 11:18:50 PM »
I am hoping someone can help me out.
What happened was I was running my cnc router with mach3 using zeta4 drives and slo sym motors 300 oz/in and the x motor overheated and the axis would not move anymore. So I let the motor cool down and tried to move the X axis but it would only move in one direction using both the + and - jog keys,I checked the settings and the hotkeys are still set properly can anyone give me any ideas on what might of happened here?

Thanks Mike ???

10
General Mach Discussion / CSS with Mach3
« on: March 01, 2010, 07:45:32 PM »
Im wondering if mach3 will work with a vector drive so that I can program CSS on my lathe?
Or is there some other way to do this?

Thanks Mike ???

Pages: 1 2 3 4 »