Hello Guest it is March 29, 2024, 01:15:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - teamtexas

Pages: 1
1
LazyCam (Beta) / Offset does work after all!
« on: March 01, 2009, 10:18:01 PM »
Well I wasn't sure if it was going to work for me or not, after everything that I read.  But I'm glad to say it did.  It took a bit of reading some of the other posts here and a little time but I managed to get the text to offset and cut out just like I needed.  What do you think

2
LazyCam (Beta) / Any way to load more than 1 dxf at a time.
« on: March 01, 2009, 12:04:34 PM »
I would like to merge two dxf's together inside of lazy cam.  Or load a dxf with a saved lazy cam project.  Is there any way to do that?

3
Good morning all, i've been lurking around for a while and have found the answers to most of my questions without needing to post.  I've built a 3 axis router table that I use to produce some plastic parts I sell on ebay.  I'm running Mach 3 with Gecko drivers and a CNC4PC BOB.

Dan

Pages: 1