Hello Guest it is March 28, 2024, 06:12:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nerginer

Pages: « 1 2 3
21
Promote and discuss your product / Re: Mach3 as 3d printer software
« on: October 26, 2010, 02:36:43 AM »
I rewrite the arduino firmware. It will not cominicate with pc. It is now standalone temperature control system. Mach3 can run smoothly now. I will let you know about the progress.

regards,
Nuri Erginer

22
Promote and discuss your product / Mach3 as 3d printer software
« on: October 25, 2010, 02:58:50 AM »
Hi,
I am a big fun of mach3. I decided to use mach3 for my homemade 3d printer like reprap or makerbot. I use an arduino for the extruder temperature control. A host software is messaging over usb (serial rs232). mach3 is controlling the 4D system via gcode. I have a problem. The serial communication has a negative effect on mach3.
the motors did not work smooth when I plug the usb.

Please send me your advice to correct this issue.

Regards,
Nuri Erginer

23
General Mach Discussion / Re: estop chargepump
« on: January 14, 2010, 12:30:43 PM »
Thanks alot for your answers

Nuri Erginer

24
General Mach Discussion / estop chargepump
« on: January 14, 2010, 03:50:49 AM »
Hi,
I need an output signal (hi/low not chargepump) when estop button pressed and released
is it possible in mach3

regards,
Nuri Erginer

25
General Mach Discussion / Re: Wireless parallel port
« on: August 08, 2006, 10:28:18 AM »
I also want to find a solution like this

26
General Mach Discussion / wireless mach
« on: August 08, 2006, 10:25:08 AM »
Did any body use such a device to use mach wireless

http://www.trendnet.com/en/products/TEW-P1PG.htm

Pages: « 1 2 3