Messages

31

General Mach Discussion / Motor Tuning cofiguration won't show up when clicked...

« on: June 21, 2013, 02:18:37 PM »

When I click Motor tuning it does not show up... All other configurations show up....

32

General Mach Discussion / Re: Motor tuning window

« on: March 25, 2012, 12:49:46 PM »

I tried reloading mach3 before I tried from the thumb drive.  I unplugged the parallel cable...  no good.    I checked lpt1 bios... no good with epp, ecp, ibm. etc.....   finally just gave up and used another computer...... 

33

General Mach Discussion / Re: Motor tuning window

« on: March 25, 2012, 08:08:58 AM »

I took a thumb drive from a running computer, plugged it in and started it from there, to see if it would still be the same.  I was surprised that I still could not get the motor tuning window to appear.  What could have this compaq different than any other unit.  The parallel port has been enabled etc.. etc...    I have given up and put my old computer back in play and put this unit in the house for a gamer for the Grandkids......

34

General Mach Discussion / Motor tuning window

« on: March 24, 2012, 10:11:20 AM »

I cannot get motor tuning window to show up on winXP pro.  Changing computers on CNC and cannot get anything to show up when I hit the Motor
tuning... Works fine on 3 other computers with XP home...  Can it be something else....

35

General Mach Discussion / stopping dro advance on a axis fault...

« on: March 03, 2012, 08:42:57 AM »

Is there a configuration in Mach that allows the advances in dro to stop on a axis fault as it does on E stop....

36

VB and the development of wizards / Re: Close Gcode button

« on: January 09, 2011, 12:39:16 PM »

Took me some time, but after wiki and forums etc.  I have figured it out... thanks for the response

37

VB and the development of wizards / Close Gcode button

« on: January 07, 2011, 11:03:29 AM »

I have downloaded a screen I like but it does not have a (Close Gcode) button.  Can I copy it from another screen?  If not how do I create one...

38

General Mach Discussion / Re: Unable to load program into mach 3 as designed. Scrambled results

« on: August 16, 2009, 02:29:48 PM »

Ok,   I went back and loaded my orig disk.  Then Upgraded to R3.042.029.   It now works fine.   I did notice that my license was missing from my mach file.  Don't know what happened to it.  That's why I reloaded and started again, of course after saving my xml file...

thanks for the help.... good to go...

39

General Mach Discussion / Re: Unable to load program into mach 3 as designed. Scrambled results

« on: August 16, 2009, 01:49:00 PM »

I have run this file before, but I may have installed a new updated version of mach since then.   R3.042.029 is the version I'm running...

40

General Mach Discussion / Unable to load program into mach 3 as designed. Scrambled results

« on: August 16, 2009, 01:23:21 PM »

I have made and saved a standard pocket program.  With the new version of mach I get scrambled results in loading. It was created in V-carve. I used mach arcs txt to save it from vectric and when I notepad it it is great, but looking at it in mach it quits after line 499 and scrambles lines after that.   Deleted mach, reloaded, reinstalled xml file all to no avail. samo samo thing.  \

Any help out there...