Hello Guest it is March 28, 2024, 04:35:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Cuemaker

Pages: « 1 2 3 4 5 6 »
11
No...  just holds. click to restart then acts dumb.  I will look into it tomorrow and post what I find...

12
Not using motion controller.  Hit spacebar to hold, then alt r to continue and does not go back into program where  halted.  Have not investigated further, but will.  after the last time when i stupidly tried to resume, and messed up, I stopped rewound and restarted to keep from it happening..

13
General Mach Discussion / NOT CONTINUING WHERE LEFT OFF AFTER FEED HOLD
« on: August 22, 2015, 01:20:02 PM »
After hitting space bar to hold and ck cutting, mach takes me off in different direction, instead of continue in sequence... causes major issues.....

14
General Mach Discussion / Re: Error on A axis in one direction...
« on: January 21, 2014, 07:09:08 PM »
After much work rechecking, I believe I have figured it out... I had not set a axis to reset on home... that caused the counter in mach to keep getting larger... I believe a overrun of the field occurred... now that I go to reset the a axis coordinate field it seems to run ok...  weird??? or not

15
General Mach Discussion / Re: RESET A AXIS MACHINE COORDINATES
« on: October 28, 2013, 07:43:24 PM »
I have it zeroed... thanks for the reply.... and answer

16
General Mach Discussion / Re: RESET A AXIS MACHINE COORDINATES
« on: October 28, 2013, 01:10:13 PM »
When my mach coord reaches 735805.9600 i get a fault.. I want to reset the mach coordinate on A axis without having to run it minus to get there.... for 735805.9600 degrees

17
General Mach Discussion / RESET A AXIS MACHINE COORDINATES
« on: October 28, 2013, 09:13:06 AM »
I want to set my A axis machine coord and work offset to 0, but when I do It sets a position to that a coord. when I then reset it it puts the # back in machilne coord..

18
General Mach Discussion / Re: Not working after update
« on: September 14, 2013, 02:22:17 PM »
I use 10160 for 3 of my axis and 200 for a axis...     See your info from manufacturer....

19
Thanks, I knew one of the codes could probably do it.  I'll give it a try....

20
General Mach Discussion / Re: Not working after update
« on: September 14, 2013, 10:47:34 AM »
Config... native units... mm or in...

Pages: « 1 2 3 4 5 6 »