Messages

11

*****VIDEOS***** / Re: Shuttle v2 Mach3

« on: March 30, 2013, 07:34:17 PM »

You have to create the macro.  The custom macro button calls the macro.

12

Brains Development / Re: Can't Read PLC from a Brain

« on: March 26, 2013, 03:44:38 AM »

Dan,

Thank you.  After searching my computer, I discovered that I had a copy.  But I am sure others will find the link usefull.  Now to make it work.

Regards,

13

Brains Development / Re: Can't Read PLC from a Brain

« on: March 25, 2013, 04:03:09 PM »

I looked for Brains User Doc under documentation but I could not find it.  I saw the videos but I would like to look at text.  Could some one point me in the right direction.  I would like to connect to my VFD using the PLC capabilities of my VFD and I want to read how to do it.

Thanks

14

General Mach Discussion / Re: Is it in Mach or Aspire to pause for the spindle to ramp up.

« on: March 03, 2013, 11:36:54 AM »

Gerry,

Thanks.  It sounds like a good number to start with.

15

General Mach Discussion / Re: Is it in Mach or Aspire to pause for the spindle to ramp up.

« on: March 03, 2013, 11:17:00 AM »

Gerry

I saw that and I misread it.  Thanks, that is exactly what I was looking for.  Do you have any suggestions for a good time?

16

General Mach Discussion / Is it in Mach or Aspire to pause for the spindle to ramp up.

« on: March 03, 2013, 11:12:08 AM »

I just added a spindle to my MechMate and when I run a file it starts cutting before the spindle is ready.  Is there a place in Mach or do I need to do it in my Aspire post processor to add a delay to give the spindle time to ramp up to the cut speed before it starts cutting?

Thanks

17

General Mach Discussion / Re: Shuttle Pro Plugin some questions...

« on: February 15, 2013, 07:44:52 PM »

Yes, it will some times continue.  If you turn the wheel back it will stop.

If you are not happy contact the shuttle pro people directly.  They stand by their product and are very helpful.  They will help you.

18

General Mach Discussion / Re: Documentation for Calibrate MPG

« on: April 07, 2012, 05:22:25 AM »

Thank you

19

General Mach Discussion / Re: Documentation for Calibrate MPG

« on: April 06, 2012, 01:58:47 PM »

You must understand how it works!  So to you it is makes sense.  But for me, I don't understand.  That is why I asked if there was any documentation that I could read.  It does not make any sense to me.

20

General Mach Discussion / Documentation for Calibrate MPG

« on: April 06, 2012, 09:05:26 AM »

Please tell me where I find the documentation for Calibrate MPG.

Thanks