1
Feature Requests / POLL: Mach3 Lathe and G70/G71/G72 roughing, facing, finishing
« on: August 22, 2008, 11:55:35 AM »
Today I just mailed Brian barker about the missing cycle's G70 G71 and G72 for lathe finishing, roughing and face roughing...
Unfortunately these cycles arent supplied with mach3 lathe... ... for me these cycles simplyfie lathe programming by hand enormously..
Even if a cam program is used these cycle's make the programming more simple..
He said the the implementing of this function wasn't on the "to do list" in the every near future.. and that he only got 5 or 6 requests in the last 5 years....
I think adding this function is a huge addition to the value of mach3.. and will make the use of this program more professional....
So If you also believe that the cycles mentioned above are a big improvement fill in this poll and let me know......
If brians list gets bigger with requests they might considder to take the time to add the function.....
PLEASE LEAVE A MESSAGE WHEN VOTING!
Best regards ..
Mcgyver
Unfortunately these cycles arent supplied with mach3 lathe... ... for me these cycles simplyfie lathe programming by hand enormously..
Even if a cam program is used these cycle's make the programming more simple..
He said the the implementing of this function wasn't on the "to do list" in the every near future.. and that he only got 5 or 6 requests in the last 5 years....
I think adding this function is a huge addition to the value of mach3.. and will make the use of this program more professional....
So If you also believe that the cycles mentioned above are a big improvement fill in this poll and let me know......
If brians list gets bigger with requests they might considder to take the time to add the function.....
PLEASE LEAVE A MESSAGE WHEN VOTING!
Best regards ..
Mcgyver