Messages

31

General Mach Discussion / Re: Driver watchdog triggered

« on: November 16, 2006, 03:00:34 PM »

I use a P4 3GHz, 1Gb ram...
Well now I know that it's only a matter o view, I was scared that it could happen during the machine working.
That job need 12-14 hours of continuous work 

Thanks

32

General Mach Discussion / Re: New CV features

« on: November 16, 2006, 03:47:08 AM »

Sorry for my errors in last reply... I'm working too much 

33

General Mach Discussion / Driver watchdog triggered

« on: November 16, 2006, 02:42:35 AM »

I was rotating the view of a 18Mb program when mach3 stops, turnig on reset button, and the "Driver watchdog triggered" appeared in the status bar.

the machine didn't working, was stopped (sorry for my english) I was just looking at the program.

What it means?

34

General Mach Discussion / Re: New CV features

« on: November 16, 2006, 02:20:28 AM »

OK,it seams to
I tryed to change the "stop CV on angle x" but nothing change or so it seems.

35

General Mach Discussion / New CV features

« on: November 15, 2006, 07:42:46 AM »

For Brian,

May you explain what these new cv features do exactly and how it works?

I add a picture that shows what I mean.

Thank you

36

General Mach Discussion / Re: looking for old version of mach3

« on: November 15, 2006, 07:36:39 AM »

thank you 

37

General Mach Discussion / looking for old version of mach3

« on: November 15, 2006, 07:01:05 AM »

I'm looking for the 2.0g version of mach3, I don't know where to download it.

I installed the new 2.0009 but have some problem, so I want to reinstal the 2.0g

Thanks

38

General Mach Discussion / Re: Pause problem

« on: October 08, 2006, 12:39:37 PM »

Sure... from a very lo value to highest value.

but nothing happen.

39

General Mach Discussion / Re: Pause problem

« on: October 08, 2006, 12:17:23 PM »

http://www.fxmodel.it/loose1.wmv

Sorry

40

General Mach Discussion / Pause problem

« on: October 08, 2006, 10:49:11 AM »

When mu machine is working and I press the "pause" button (yellow) it stops immediately without a deceleration ramp.
It causes steps loose, a lot.

You can see it here www.fxmodel.it/loose.wmv ... ehm sorry I imitate the bad noise with my voice in the video ehehe.

I tired with 2 different pc, one is a celeron 1ghz the other is a p4 3ghz, in the lastone the "drive test" graph is flat absolutely flat.

Thanks Faby