Hello Guest it is December 09, 2021, 09:28:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - krymis

Pages: « 1 2 3 4 5 6 »
11
G-Code, CAD, and CAM discussions / Bobcad V21 and V23 post
« on: August 19, 2011, 10:54:34 AM »
I need a post for bobcad v21 and bobcad v23 that output a good code.  I had one on my old computer but now that i upgraded i lost it.  Any help would be appreciated. 

12
General Mach Discussion / Re: pinning an existing fixture plate
« on: August 19, 2011, 07:49:27 AM »
thanks guys.

13
General Mach Discussion / Re: pinning an existing fixture plate
« on: August 18, 2011, 10:50:25 PM »
do you think that would work and what would be some other options. 

14
General Mach Discussion / Re: pinning an existing fixture plate
« on: August 18, 2011, 09:20:56 PM »
how do i go about setting an origin for this plate as opposed to one i cut on my own?  do i just put a bolt with the head cut off in one corner and use that as an origin dowel? 

15
General Mach Discussion / pinning an existing fixture plate
« on: August 18, 2011, 04:15:19 PM »
I have 2 fixture plates from HTS that are already drilled and tapped with 170 holes on a 1/2 grid pattern.  How would i go about pinning the fixture plate to the mill table properly.  I guess my biggest confusion would be squaring it up first and then drilling where the dowel holes are in the mill table already.  How should you square the fixture?   I could put 2 pins a certain distance apart and then put a peice of steel square stock against them and use a DTI to set the stock square inturn squaring the dowel and table ?????just thinking out loud. 

17
Members Docs / Industrial Hobbies Milling Tips
« on: August 17, 2011, 12:25:15 PM »
here are the files that i converted into pdf for one of the members.  Once again i did not write this stuff i copied it from the original indusrtial hobbies website and all stuff written by Aaron Moss.

18
General Mach Discussion / Re: Old Industrial Hobbies Tech pages
« on: August 17, 2011, 06:31:43 AM »
i will start copying them to pdf tonight and start a new post called mill tips.

19
General Mach Discussion / Re: Old Industrial Hobbies Tech pages
« on: August 14, 2011, 05:23:42 PM »
here is the whole automatic tool changer post.  I also have all of the old files saved with pictures from back in 06-07 when the company had all the mill tips and production tips up.

20
General Mach Discussion / Re: Old Industrial Hobbies Tech pages
« on: August 13, 2011, 01:52:32 PM »
i was thinking that there would be a way to make the spindle and coolant start after you hit cycle start and then hit cycle start again to start the movement.  i may be making this more difficult that it should be.  I have not successfully implemented this on a machine yet.  This will be the one to do it.  Do you have any advice for me.

Pages: « 1 2 3 4 5 6 »