Messages

91

Finished Screens / Re: New User Friendly Practical Lathe Screen (with space shuttle acc.)

« on: August 02, 2009, 05:27:42 AM »

hi scott,

very nice screen. i found almost all of the bitmaps an .jpg except:
dark-gry_recessed.bmp
feedpanel.jpg
speedpanel.jpg
panelbackground.jpg

is it possible to become these somehow?

thanks, Antoine
the netherlands

92

PoKeys / Re: How I made my pendant.

« on: July 09, 2009, 11:38:24 AM »

hi,

yes rewrite it.

93

PoKeys / Re: How I made my pendant.

« on: July 09, 2009, 11:16:30 AM »

hi,

i had the error aswell. i retyped the brain, all works well.

94

PoKeys / Re: How I made my pendant.

« on: June 28, 2009, 10:43:25 AM »

ok thanks,

i found it. i looked into the .pdf manual and there i could not find it.

thanks!

Antoine

95

PoKeys / Re: How I made my pendant.

« on: June 28, 2009, 03:18:19 AM »

hi hood,

thanks for your reply, but i think there should be an attachment or so?

thanks

antoine

96

PoKeys / Re: How I made my pendant.

« on: June 27, 2009, 03:52:43 PM »

OK thanks hood,

that saves me typing them. last question: i cannot find on the forum or manual how the pokeys i/o is treated as modio

thanks again,

antoine
the netherlands

97

PoKeys / Re: How I made my pendant.

« on: June 27, 2009, 03:36:43 PM »

hi hood,

is it possible to become your "brains" you made for the FRO and SRO pots.

thanks

antoine
the netherlands

98

General Mach Discussion / Re: mach3 lathe

« on: January 22, 2009, 03:03:52 PM »

ok, thanks. i am gone try that

antoine

99

General Mach Discussion / mach3 lathe

« on: January 22, 2009, 02:19:47 PM »

hi,

I use mach3 for milling and Turning. what i miss really in turn is the feed overide during running. will that be implemented somewhile?

thanks

Antoine
The Netherlands

100

General Mach Discussion / Re: using motoroutput as normal digital output

« on: November 20, 2008, 12:25:42 PM »

hi,

thanks for your reply, i use the MACH 3 BREAKOUT BOARD from cncdirect. it is really an i/o board. but i will give it a try,

thanks.

antoine