21
General Mach Discussion / Re: A axis as extruder
« on: August 03, 2013, 11:21:56 PM »
Yes, thanks, it sounds right. But I don´t want to edit 10.000 lines of Gcode :-)
Is there a check box somewhere that can change it?
I´m using software called Slic3r ( Slicer), which is made for reprap, so I guess the generated Gcode is ok.
Is there a check box somewhere that can change it?
I´m using software called Slic3r ( Slicer), which is made for reprap, so I guess the generated Gcode is ok.