41
General Mach Discussion / inconstant speeds?
« on: February 27, 2008, 08:48:14 PM »
Hope this is an easy fix.
Mach3 and a HobbyCNC driver board on a 3 axis CNC.
The part file is set to cut at 100units/min and on the lines every thing moves at those speeds. When I get to a curve every thing slows way down, 30ish. I know that the G-Code only has the speed set to 100. Is there a setting in mach3 that I need enable/disable?
Mach3 and a HobbyCNC driver board on a 3 axis CNC.
The part file is set to cut at 100units/min and on the lines every thing moves at those speeds. When I get to a curve every thing slows way down, 30ish. I know that the G-Code only has the speed set to 100. Is there a setting in mach3 that I need enable/disable?