Messages

71

General Mach Discussion / Re: possible controller?

« on: October 17, 2006, 05:22:09 PM »

Look pretty sweet ! 

72

General Mach Discussion / Re: What is the best Cad / Cam software?

« on: October 16, 2006, 04:51:57 PM »

Sweet.
Thanks Paul !!


Paul in Grand Prairie Tx.

73

General Mach Discussion / Re: What is the best Cad / Cam software?

« on: October 16, 2006, 03:28:25 PM »

Thanks .
I need to go as cheap as I can.
Already in 2800.00 on this Mill and still need to build the table for Flood Cooling.
 

74

General Mach Discussion / Re: What is the best Cad / Cam software?

« on: October 16, 2006, 02:46:53 PM »

Will TC 11.2 save as a dwg/dxf format ?

75

General Mach Discussion / Re: What is the best Cad / Cam software?

« on: October 16, 2006, 10:22:21 AM »

Saw those but wasnt sure. Thanks.
Sure Wish LCam could "create" a part , instead of modifying an existing drawing. 

76

General Mach Discussion / Re: What is the best Cad / Cam software?

« on: October 16, 2006, 09:26:47 AM »

Paul.
Any idea what that app cost ?

77

General Mach Discussion / Re: Homing weirdness

« on: October 15, 2006, 03:14:05 PM »

Not being lucky enough to have a breakout board I just fire the two controllers up after
Windows and Mach are running.

78

General Mach Discussion / Re: Homing weirdness

« on: October 15, 2006, 10:39:57 AM »

Thanks again Hood'ster
I ran it up too 1000 and it homes just fine.
Kinda weird as even a super slow Jog worked fine before.
Oh well.
As long as it works !!
 

79

General Mach Discussion / Re: Homing weirdness

« on: October 15, 2006, 09:30:18 AM »

Hmmm.
I have uber sheilded everything.
And the slow jog works smooth as butta'.
I'll crank it up and see what happens.
Thanks Hood.

80

General Mach Discussion / Re: Homing weirdness

« on: October 14, 2006, 07:42:44 PM »

Suppose I need to upgrade  running 1.84.001
It was under config/Logic

I went from zero up to 20 in increments of one.
It made it go longer before stalling but still stalled after about an inch ??
What is the average setting ?
Not sure what it does actually.