Messages

61

General Mach Discussion / Re: Water tight keyboard

« on: October 24, 2006, 04:23:57 PM »

Anybody in the DFW Tx. area.
Tanner electronics has a soft and sealed usb keyboard for 17 bux.

62

General Mach Discussion / Re: check disk

« on: October 24, 2006, 11:00:15 AM »

Shouldnt do that if your shutting down gracefully
Does it find and repair a problem everytime it scans the drive ?

63

General Mach Discussion / Re: Wireless Network Not Connected

« on: October 23, 2006, 05:22:23 PM »

lol
Sorry showing my age again.


Bizzare how just running Mach kills the signal.

64

General Mach Discussion / Re: Wireless Network Not Connected

« on: October 23, 2006, 04:51:30 PM »

Does it happen when Mach is up or when the Machine is running ?
It has to be interferance from something.
I just use "sneaker"net between my two PC's .
USB stick handles it well.

65

General Mach Discussion / Re: blue screen of death

« on: October 23, 2006, 08:37:03 AM »

Hood beat me to it   
That is correct.

66

General Mach Discussion / Re: Memory leak in Mach3 ver 2.0

« on: October 22, 2006, 09:29:10 AM »

I believe Brian meant to run the Drivertest program.
It should be in the Mach3 directory.

Should be a fairly smooth graph without alot of spikes.

67

General Mach Discussion / Re: Controller for New Hermes Vanguard 3000 Engraver

« on: October 20, 2006, 03:53:25 PM »

Seems like you can get a 3 axis stepper controller that uses parallel and bypass the controller
that is has now.
But then the Font cartridge thing would be gone.

68

General Mach Discussion / Re: Controller for New Hermes Vanguard 3000 Engraver

« on: October 20, 2006, 03:24:02 PM »

Does the engraver use steppers for the 3 axis's ?
If so it shouldnt be to hard to get it going.

69

General Mach Discussion / Re: blue screen of death

« on: October 20, 2006, 09:01:59 AM »

Not at all a Mach guru but Ive been in the PC service biz for EON's.

It should have a filename or error code that its having issues with in the Blue screen.
Write that down and post it here.

70

General Mach Discussion / Re: Tapping on a mill--- HELP !?!

« on: October 20, 2006, 08:53:34 AM »

I gotsta' get a GCode for dummies book   
Had no idea it could do that kinda stuff.

Hey chad .
ever seen one of these puppies run ?

http://www.tapmatic.com/flash_tap.html