Topics

11

General Mach Discussion / MPG-Mode Question..

« on: December 08, 2006, 05:53:00 PM »

Hi,

I`ve a little bit problems to understand the MPG movement modes...

In velocity mode my axis runs in dependance of my turning speed - ? ok!

In step / velocity mode my axis moves at lower turning speed with the set step-size from cycle step mode?
At higher speed it switched to velocity mode, as calibrated or set in MPG-Setup.

But my steps are independant of the cycle steps setting and not fine enough to touch a surface or an edge..
My settings are 4 Imp / detent, vel 100, 40%..

Whats wrong??


The single / Multistep modes are ok, but to slow to jog over the whole table..


Thanks and Greetings,

Wolfram

12

General Mach Discussion / Toolpath in Lathe-Mode

« on: December 07, 2006, 01:20:10 PM »

Hi,

I have a really simple question....

How can I rotate the toolpath display in turning screens?

Ive checked the video, but with left mouse button and moving the displays will be zoomed in and out,
with right mouse button it will be panned.....

Nor shift and Ctrl combination will work too....

Thanks for a short hint...

Wolfram

13

VB and the development of wizards / OEM DROs in Wizards

« on: November 24, 2006, 03:43:27 PM »

Hi,

Ive used a lot of OEMDROs in my screens to configure toolmeasure and change...

What happens  if I use the same OEM-DRO numbers in sev. wizards? Ive tested it and
it seems to work fine, but Im not shure not to have progrmming side effects later...


Thanks and Greetings,

Wolfram

14

VB and the development of wizards / Changing Homing-Speed with VB

« on: July 21, 2006, 10:14:41 AM »

Hi,

I want to change the Homing-Speed inside of a VB-Script, but cant find the
Variable for this?
Has anybody done this before or an information about this?
Thanks for a short hint...

Greetings Wolfram