81
G-Code, CAD, and CAM discussions / Re: Double taper
« on: May 18, 2008, 05:11:01 AM »
Hi Graham,
Thanks for this however is it possible to calculate using the xstart and xend and the zstart and end, without having to know the (small?)diameter of the job?
With the wizzard for taper how does it facter the angle you imput?
Also one last question is it in radians or degrees?
Thanks,
Sorry for the questionaire
Andy
Thanks for this however is it possible to calculate using the xstart and xend and the zstart and end, without having to know the (small?)diameter of the job?
With the wizzard for taper how does it facter the angle you imput?
Also one last question is it in radians or degrees?
Thanks,
Sorry for the questionaire
Andy