21
General Mach Discussion / Re: Pulley Setup......Yes i know but just dont understand it??
« on: December 06, 2013, 08:49:46 AM »
Libbet,
I have the same problem. I did my machine about 2-1/2 years ago.
When running in low range I have to use M04 to run the spindle forward. People have told me it is a glitch in the version of Mach that I am using.
It needs to be updated, but it is running too good. Hopefully in the next month I will do this. Then the machine can power tap.
Check your version of Mach.
Jackal
I have the same problem. I did my machine about 2-1/2 years ago.
When running in low range I have to use M04 to run the spindle forward. People have told me it is a glitch in the version of Mach that I am using.
It needs to be updated, but it is running too good. Hopefully in the next month I will do this. Then the machine can power tap.
Check your version of Mach.
Jackal