1
Finished Screens / Re: Chucks – LED City set
« on: March 25, 2008, 05:19:40 PM »
This point to point update has 2 basic modes
Auto – when you first open it will.
Turn on the spindle and wait for coolant to prime and use feed rate any time you move and below 0.0000 on the z-axis for all axis.
When you are above 0.0000 z-axis it will use rapid rate for all axis moves.
If you move the z-axis from a +number to a - number it will go to .120 stop turn on spindle wait for coolant to prime then cut.
Any z-axis move up will use rapid rate.
Manual – hit the manualbutton will.
No matter what move you make they will always move at the rate you set with no spindle stuff.
I also added the ability to set the x and y axis separately for each of the 9 points and more status info.
Auto – when you first open it will.
Turn on the spindle and wait for coolant to prime and use feed rate any time you move and below 0.0000 on the z-axis for all axis.
When you are above 0.0000 z-axis it will use rapid rate for all axis moves.
If you move the z-axis from a +number to a - number it will go to .120 stop turn on spindle wait for coolant to prime then cut.
Any z-axis move up will use rapid rate.
Manual – hit the manualbutton will.
No matter what move you make they will always move at the rate you set with no spindle stuff.
I also added the ability to set the x and y axis separately for each of the 9 points and more status info.