Topics

151

LazyCam (Beta) / MOVED: Lazy Cam

« on: November 28, 2019, 01:06:12 AM »

This topic has been moved to Russian.

https://www.machsupport.com/forum/index.php?topic=42123.0

152

Mach4 General Discussion / MOVED: Input c# using Mach4

« on: November 20, 2019, 01:45:42 AM »

This topic has been moved to General Mach Discussion.

https://www.machsupport.com/forum/index.php?topic=42052.0

153

VB and the development of wizards / MOVED: Input c# using Mach4

« on: November 14, 2019, 03:20:31 AM »

This topic has been moved to Mach4 General Discussion.

https://www.machsupport.com/forum/index.php?topic=42052.0

154

Tangent Corner / Slow on the uptake.

« on: November 10, 2019, 06:37:10 AM »

I must admit to being a little slow on this one but…

Last week whilst organising an electrical repair on the hoist brake of a dockside crane I happened to notice, in a small adjacent dock, 4 guys getting a Pool Table on board a 60 foot (or so) private boat. Three of the guys were struggling to get the table in through the saloon doors and the fourth guy had the easy job of carrying a 5 foot spirit level. It took them quite a while but they managed it in the end.

It was not until driving home that afternoon, thinking it would be nice to own a Pool Table, I started wondering just how the fourth guy was ever going to 'level-up' a Pool Table on board a Boat !!

Tweakie.

155

Mach3 and G-Rex / MOVED: Steps per inch calculated does not work as input into Mach 3 "steps per" tuning

« on: November 04, 2019, 01:39:09 AM »

This topic has been moved to General Mach Discussion.

https://www.machsupport.com/forum/index.php?topic=42012.0

156

General Mach Discussion / MOVED: System recommendation for newbie

« on: November 04, 2019, 01:31:21 AM »

This topic has been moved to Mach4 General Discussion.

https://www.machsupport.com/forum/index.php?topic=42015.0

157

General Mach Discussion / MOVED: extra small font on Mach 4 screen Help please

« on: November 03, 2019, 01:38:56 AM »

This topic has been moved to Mach4 General Discussion.

https://www.machsupport.com/forum/index.php?topic=42003.0

158

General Mach Discussion / MOVED: how to use screen "CycleStop" in macro script

« on: October 12, 2019, 09:49:30 AM »

This topic has been moved to Mach4 General Discussion.

https://www.machsupport.com/forum/index.php?topic=41907.0

159

General Mach Discussion / MOVED: Reinstalling Mach 4 on New PC

« on: October 08, 2019, 01:28:55 AM »

This topic has been moved to Mach4 General Discussion.

https://www.machsupport.com/forum/index.php?topic=41880.0

160

Forum suggestions and report forum problems. / MOVED: Input pins Waltz!

« on: September 20, 2019, 01:15:29 AM »

This topic has been moved to General Mach Discussion.

https://www.machsupport.com/forum/index.php?topic=41795.0