Hello Guest it is April 16, 2024, 11:51:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dfurlano

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 »
181
General Mach Discussion / Re: Fonts
« on: January 15, 2007, 04:52:44 PM »
I did a search on their forum and found a post that asked about controlling a rotary axis and the answer was that vcarve pro cannot output to a rotary axis.

182
General Mach Discussion / Re: Fonts
« on: January 15, 2007, 03:56:56 PM »
No, I just read the web site. Didn't see anything about an A axis output.

Dan.

183
General Mach Discussion / Re: Fonts
« on: January 15, 2007, 03:46:56 PM »
But I do not think vcarve has a rotary output????

Dan.

184
General Mach Discussion / Re: Fonts
« on: January 15, 2007, 02:19:44 PM »
I have read about artcam pro.  How is the learning curve?  Does it have good features?  I assume it can do a rotary axis with no problems?  Any limitations that you have run into?

Thanks.

dan.

185
General Mach Discussion / Re: Fonts
« on: January 15, 2007, 01:21:33 PM »
What cam and cad packages do you guys have?

186
General Mach Discussion / Re: Fonts
« on: January 15, 2007, 08:17:41 AM »
Well, maybe I don't understand something.  I would like to cut some very small text.  When you use a "regular" font and convert it for engraving it creates a double line that loses it's definition when cut, unless you use a laser.  I would like to try and find some single line fonts that would yield a finer cut line.

187
General Mach Discussion / Fonts
« on: January 14, 2007, 11:08:35 PM »
Anyone know of any free engraving fonts? I know about the write wizard but I am looking for other single line fonts.

Dan.

188
It is Mylan's friction polish which is a shellac based finish. 

189
Show"N"Tell ( What you have made with your CNC machine.) / Re: Re: radius
« on: January 12, 2007, 08:24:45 AM »
Marcel,

Bosco's website is amazing!  And I see you are on his links!

http://perso.orange.fr/robert.bosco/modeleen.htm

190
G-Code, CAD, and CAM discussions / Re: gcode to dxf converter
« on: January 07, 2007, 09:23:12 PM »
Thanks for the help.

Dan.

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 »